THE SAFEST WAY
TO CHAIN DOWN
THE BOSS MAKES YOUR JOB EASIER
The time consuming job of extending and retracting your load binder is a thing of the past with the BOSS.
The BOSS is geared to multiply the torque of your drill at least 15 times. The added torque makes it easy to tighten your chains securely with any quality cordless drill.
One hand is all that is needed to hold the drill under full torque. There is no stress on the hand, wrist and arm. The drill operates at a position that keeps your hand and fingers out of harms way at all times.
The BOSS definition of efficiency: Achieving maximum productivity with minimum wasted effort and time. The BOSS makes the slow, tedious and physically demanding job of using load binders effortless and quick.
USE THE BOSS IN POWER OR MANUAL
BUILT TO LAST
You can see that quality is built into every Load Binder BOSS. Aluminum and stainless steel throughout. All aluminum frame. Tough but light weight. Will never rust. Stainless steel drive. Drive shaft, drive screw and drive nut are made from wear and corrosion resistant stainless steel. Ball bearings, not bushings, on drive shaft provide trouble free operation and more efficient transfer of power. The Boss is built to give many years of trouble-free service under the harshest of conditions.,
You can see that quality is built into every Load Binder BOSS and Load Binder Buddy. Which one should you pick? The BOSS gets it torque from gearing which makes it slower but powerful. The BUDDY gets it torque from speed. The BOSS is fast but the BUDDY is even faster. The Buddy has enough torque to tighten most loads adequately with the drill in seconds while using less battery power. The Buddy is easier to install and fits on more brands than the BOSS. We recommend you contact us before purchasing the BOSS to insure it will fit on your binder. For manual operation the BOSS requires the drive screw be separated from the spur gear manually. It is easy to do but takes time. The Buddy is in drill mode or manual mode at all times. This makes it faster and easier for the operator. The BOSS requires that the drill be operated by the left hand in order for the torque of the drill to be absorbed by the handle. The BUDDY can be operated with either hand. The torque of the drill when using the BUDDY is absorbed by either the deck or the shaft of the binder when operated properly. We encourage you to look closely at the operation and benefits that both products provide and pick the right one for you.
boss or buddy
Which to Buy?
THE BOSS SAVES TIME & MONEY
We designed the BOSS to install easily on your existing ratchet load binder on purpose. Why replace the one that you already own, you already paid for it! The BOSS attachment gives you the best chain tie down for less.
The load binder BOSS can be transferred to a new load binder should your binder become damaged or worn out. Because of the long service life built into the load binder BOSS you can amortize the cost over several years. Time is money. The time saved using the BOSS will pay for it many times over.